Resetting the 2004 Honda Accord oil life indicator is a simple process that can be done using the vehicle’s odometer. Here are the general steps to follow:
- Position the key in the “ON” position, but do not start the engine.
- Use the odometer button to toggle through the odometer readings until the “MAINT REQD” light comes on.
- Press and hold the odometer button for about 10 seconds, or until the “MAINT REQD” light starts flashing.
- Release the odometer button and the indicator light should turn off, indicating that the 2004 Honda Accord oil life has been reset.
- Turn off the ignition and you’re done.
It’s important to note that resetting the oil life indicator does not change the oil, It just resets the indicator to 100%, which tells the driver when it’s time to change the oil based on the vehicle’s usage. It’s always important to follow the manufacturer’s recommended 2004 Honda Accord oil change schedule and to use the recommended oil type and viscosity.
It’s also good to check the owner’s manual or consult with a Honda dealer to ensure you are using the correct method to reset the oil life indicator for your specific year, make and model of the Honda Accord.
How To Reset 2004 Honda Accord Oil Light On A Car?
You can reset your 2004 Honda Accord oil light on a car by pressing and holding the numbers in sequence down:- 0, 1, 2 and 3. On most models you have to wait for a few seconds before continuing. If this does not work, turn off the engine and open up your hood.
Remove the oil filter using an oil filter wrench, then remove the top bolt directly above it located on top of the valve cover. (On some models there are 2 bolts instead of 1). Then unscrew it until you can see through it. Leave it at least 12 inches from actual engine block with the end facing downward approximately vertical.
Once you have done this, wait for a few minutes and check if any 2004 Honda Accord oil has started dripping down into the pan. If it has not, then put the oil filter back on and tighten it using an oil filter wrench.
Once the 2004 Honda Accord oil starts dripping into the pan, then it is time to replace the valve cover gasket. Remove all bolts holding the valve cover in place using an oil filter wrench. Do not remove any bolts that are located on top of your 2004 Honda Accord engine block! Then pull off your 2004 Honda Accord valve cover with a pair of pliers and set it aside.
Does A 2004 Honda Accord Oil Require Specific Type?
Yes, a 2004 Honda Accord oil requires specific type of oil. The type of 2004 Honda Accord oil you need to use depends on the amount of miles your car has driven and what year model it is. It’s important that you find out this information before purchasing any 2004 Honda Accord oil. It is important to use the right type of 2004 Honda Accord oil in your car.
You do not want to use a synthetic or full synthetic oil if your engine is designed to use regular or conventional 2004 Honda Accord oil. The same goes for diesel engines, as they require different types of lubricant than gasoline engines.
If you have any doubt about whether your vehicle requires synthetic or full synthetic 2004 Honda Accord motor oil, then check the owner’s manual. However, it is recommended that you use a high quality 2004 Honda Accord oil filter. Cheap 2004 Honda Accord oil filters may cause problems with your engine and cause leaks in the future.